Mittler-bros-machine-tool 2500-400 Bend Stop User Manual download pdf

Division of Mittler Corp.

P.O. Box 110 Foristell, Missouri 63348

10 Cooperative Way Wright City, MO 63390

(636) 745-7757

Fax: (636) 745-2874

\\Mbserver01\Engineering\Product\Product Documentation\2500 180 HYD Bender\Bend Stop Hook Up Instructionsl.doc Rev1 12-14-2005

Lower

Elbow for

Shop Air

2500-400 Bend Stop

For 2500 180° Hydraulic Bender

1. Bolt the bend stop air switch and Mounting Bracket assembly onto the machine. Position

yourself at the side of the machine so your left hand is near the hydraulic cylinder and your right

hand is closest to the digital read out. Underneath the machine top, the two bolts closest to you

that hold the bearing block in place need to be removed. (see next page for orientation of machine)

2. Slip the supplied Washers over the bolts and then slip the bolts through the stop Mounting

Bracket. Thread the bolts back into the bearing mounting holes. Tighten these bolts back down.

3. Hook your shop air supply to the Lower Elbow Fitting on the bend stop.

4. Hook the loose end end of the Supplied Hose to the Upper Elbow and then to the air inlet of

your air-hydraulic pump.

5. Leave the Actuator Arm Assm. off. Check the benders operation by stepping on the air-

hydraulic unit pedal and be sure the bender operates correctly.

6. Bend a sample piece of tubing to the desired degree using the Digital readout set MM. Stop the

bender but do not release the pedal.

7. Slip the Actuator Arm Assm. over the main shaft and lightly tighten the clamping bolts.

Actuator Arm

ssm.

Bend Stop

Air Switch

Button

Supplied

Hose. Connect to

Air Hydraulic

Pump

Upper

Elbow

Adjuster

Bolt

Washer:

Between

Bolt Head

& Bracket

Mounting

Bracket

1 2

2500-400 Bend Stop 1

Summary of Contents

Page 1 - 2500-400 Bend Stop

Division of Mittler Corp. P.O. Box 110 Foristell, Missouri 63348 10 Cooperative Way Wright City, MO 63390 (636) 745-7757Fax: (636) 745-2874 \\

Page 2

Digital read Out End. Right side Hydraulic Cylinder End Left Side Bend Stop Location. Under Main Bender Assm 8. Rotate the Actuator Arm Assm. until

Mittler-bros-machine-tool 2500-400 Bend Stop User Manual

Browse online or download User Manual for Accessories for water Mittler-bros-machine-tool 2500-400 Bend Stop. Mittler Bros Machine & Tool 2500-400 Bend Stop User Manual

Summary of Contents

More documents for Accessories for water Mittler-bros-machine-tool 2500-400 Bend Stop

Comments to this Manuals

Mittler-bros-machine-tool 2500-400 Bend Stop User Manual

Browse online or download User Manual for Accessories for water Mittler-bros-machine-tool 2500-400 Bend Stop. Mittler Bros Machine & Tool 2500-400 Bend Stop User Manual

Summary of Contents

More documents for Accessories for water Mittler-bros-machine-tool 2500-400 Bend Stop

Comments to this Manuals

Related products and manuals for Accessories for water Mittler-bros-machine-tool 2500-400 Bend Stop